Perpendicular Line Preferences

Doubleclicking the Perpendicular Line tool in the toolbox (or pressing the Enter key when the tool is selected) will bring up its preferences dialog, which it shares with the Tangent Line tool:

Perpendicular Line Preferences Dialog

1. Annotate Line Length

When enabled, the current length of the perpendicular line is displayed next to the cursor.

2. Snap Tolerance

The tolerance for the cursor when snapping to existing paths. If Smart Guides are turned on, the Smart Guides tolerance value is used if it is larger than the specified value.

3. Snap When Smart Guides are Off

When enabled, and Smart Guides are turned off, the cursor will still snap to paths using the specified Snap Tolerance.

4. Add Points to Existing Paths

When enabled, anchor points will be added to the existing path(s) at the points where the perpendicular line begins or ends. A dot appears next to the cursor to indicate that this mode is active. The preference may be inverted on the fly by pressing the Option/Alt key when using the tool.

5. Perpendiculars Bisect Corner Points

When enabled (the default), corner anchor points are considered to have a perpendicular which bisects the angle made by the path at that point; otherwise, the perpendicular is made to the angle of the path entering or leaving the point.

Perpendicular Line - Bisect Preference

6. Ignore First Path When Starting at Corner

When enabled (the default), and a path-to-path line is begun at a corner anchor point, the first path is ignored for the purposes of making the line perpendicular to it. To ignore the first path even when not starting on a corner point, use the Increase Diameter keyboard shortcut key (see Perpendicular Line: Tool Operation).

7. Informational area

Shows a brief description of each preference control when the cursor is being hovered over it.